Axle Washers

Mini-Logo Axle Washers

Axle Washers (Also known as Axle Spacers, Speed Washers or Speed Rings) are small metal rings that you slide onto your truck axles to encapsulate the bearings between the hanger and axle nut. These are meant to create a smoother ride and help prolong bearing life. You put one axle washer between the hanger and inside bearing, and another one between the outside bearing and the axle nut. This helps reduce friction, limit slop and keep your bearings from binding up. Without axle washers your bearings can end up rubbing against the truck hanger and axle nut.

Freestylers also use axle washers to adjust axle depth and where the Wheels sit in relation to the edge of the Deck. By putting multiple axle washers behind the wheel, you can push your wheels outward, bringing the axle further inside the wheel (to avoid axle contact with the pavement), or to adjust the wheel-span for optimal rail alignment.

This wheel has no axle washers installed on the inside bearing so the axle is almost flush with the outside of the wheel. We'll want to bring that in a bit.

2 axle washers were installed to bring the axle further into the wheel and extend the wheel out a bit further.

This wheel now has 2 axle washers installed on the inside so there is now a good buffer between the axle and the outside edge of this Momentum Kevin Harris M80 Freestyle Wheel.

With regards to wheel-span, the wheels should never extend past the edge of the board. Placing the wheels even with the board will, however, help with Rail Whips because it lessens deck drag. Bob Loftin recommends an optimal wheel-span somewhere around 1/8" to 1/4" narrower than the Deck. It is all a matter of preference, but this range can provide better rail stability. Just try some different settings and see which configuration works best for you.

This Seismic Focus (Gen2) 97A Wheel is set back 1/16" from being flush with the rail of this Decomposed Per Canguru Caged Critter Deck, which sets the total wheel-span 1/8" narrower than the deck.